Siko KA485ETC Kurzanleitung Seite 2

Quick Start Guide
KA485ETC
Adapter
General information
Prior to installation, including in hazard areas, read the Installation Instruc-
tion (download from the internet). It contains the safety instructions, hints
and technical data to be observed during installation. Subject to change with-
out notice.
Caution
In order to ensure reliable functioning of this product, take care to transport,
store, position and mount it appropriately. Exercise care when you operate and
maintain the device. Only properly qualified personnel is authorized to install
and operate this product.
Safety information
It is important for safety reasons that you read and understand the below
instructions before you install the system:
• Installation, connection, commissioning and maintenance shall be done by
properly qualified personnel.
• It is the responsibility of the customer to ensure that the personnel con-
cerned read and follow the instructions and directions of this Guide and of
the Installation Instruction.
• It is the responsibility of the customer to ensure that the adapter is cor-
rectly connected and configured.
• Only personnel specifically trained by SIKO shall execute repair and mainte-
nance work.
SIKO GmbH
Weihermattenweg 2 Phone: + 49 7661 394-0
79256 Buchenbach Fax: + 49 7661 394-388
www.siko-global.com Service: support@siko-global.com
KA485ETC · Date 02.09.2019 · Art. No. 90041 · Mod. status 172/19
Mechanical mounting
Use 2 fastening screws for mounting the adapter to a control system
1
ETC5000.
1
3
2
Electrical Installation
The additional operating voltage must always be connected to ETC5000's
2
terminal clamp 3 .
Pin assignment Bus
PIN Designation
1 DÜB
2 DÜA
3 +UB
4 GND
Pin assignment interface RS485
PIN Designation
1 GND
7 GND
12 DÜA
13 DÜB
21 +5 V Out (for level
setting)
2-6, 8, 14-20, do not connect
22, 24, 25
9-11, 16, 17, 23 nc
Pin assignment operating voltage
Color Designation
red +UB
black GND (-)
1
2
4
3
viewing side = plug-in side
1 13
14 25
viewing side = plug-in side