Bodypoint PC101 Installationsanleitung

PC101
Joystick Handles are designed with flexible shafts
that will fit tightly on 5mm (3/16") or 6.4mm (1/4")
joystick stems. All Bodypoint Joystick Handles with
flexible shafts will, by design, rotate or slide off of
the steel joystick stem if subjected to undue pulling.
This is to prevent damage to the joystick box.
Altering the product to circumvent this feature is not
recommended.
INSTALLATION INSTRUCTIONS
1. Clean the metal joystick stem to remove any dirt
or oil.
2. Moisten the metal joystick stem to facilitate
mounting the handle.
3. Grasp the metal joystick stem near the base with
pliers to keep from pushing it into the sensitive
electrical components of the joystick box.
4. Press the Joystick Handle onto the metal joystick
stem with a twisting motion.
WARRANTY
This product carries a limited lifetime warranty
against defects in workmanship and materials arising
under normal use by the original consumer. Contact
your supplier or Bodypoint for warranty claims.
558 First Ave. S., Suite 300 | Seattle, WA 98104 | 206.405.4555 | 800.547.5716 | www.bodypoint.com
© 2019 Bodypoint, Inc. All rights reserved.
Joystick Handle
PC102 PC104 PC107
PC110 MODIFICATIONS
Handle can be cut down using
a sharp knife (roll through cut
for best results) 28mm (1-1/8")
min height
MDSS GmbH
Schiffgraben 41
D-30175 Hannover
Germany
en
PC110
BPI025-en 2019.9