Sanyo VA-80EX Installationsanleitung

INSTRUCTION MANUAL
Outdoor Housing
This installation should be made by a qualified service
person and should conform to all local codes.
About this manual
This housing is designed for outdoor installation.
Before installing and using this unit, please read this manual carefully. Be sure to keep it handy for later reference.
Example of
wall mounting
Accessories
Screws, washers
(for power board unit)
Features and specifications are subject to change without
prior notice or obligations.
Example of
pendant mounting
Hexagonal wrench
Waterproof tape
VA-80EX
CAUTION:
Install this housing securely according to this
installation manual. Be aware that allowing the bracket
to fall with the camera on it may cause personal injury.
Important
• Be careful when opening holes for installing the
unit. Work with the power and video cables pulled
out for easy installation.
• Make sure to properly perform waterproofing for the
ceiling or wall where you are installing the unit.
• Make sure that the surface in the installation
location has no unevenness and is strong enough
to bear the total weight of the unit.
b Specifications
Color: Beige
Material: Metal
Waterproof Standard: Conforming to IP66
Operating Environment
(with power source connected) :
Temperature; -30°C - +50°C (-22°F - +122°F)
Humidity; less than 90% RH (no condensation)
Weight: Approx. 2.5 kg (5.5 lb)
Dimensions:
248 (9.8)
b Specifications of Heater
(built into VA-CM8C/CM8S)
Automatic switch ON/OFF temperature:
ON; Approx. 5°C (41°F)
OFF; Approx. 15°C (59°F)
Power supply: 24 V AC ± 10%, 50/60Hz
Power consumption: Max. 35 W (When heater turned on)
Unit: mm (inch)