Resetting The Microprocessor; Setup Menu - Pioneer MVH-MS510BT Bedienungsanleitung

Resetting the microprocessor

The microprocessor must be reset in the following situations:
– Before using this unit for the first time after installation
– If the unit fails to operate properly
– When strange or incorrect messages appear on the display
1
Remove the front panel (page 4).
2
Press the RESET button with a pointed instrument longer than 8 mm.

Setup menu

When you turn the ignition switch to ON after installation, the setup menu appears in
the display.
NOTE
If your boat's ignition has no ACC position, some settings are not saved to the memory. To save, detach
the front panel or wait for the unit to shut off completely 10 seconds after turning it off by pressing and
holding SRC/OFF (when [ON] is selected in [PW SAVE]), then turn the ignition off.
WARNING
Do not use the unit in standard mode when a speaker system for network mode is connected to the
unit. Do not use the unit in network mode when a speaker system for standard mode is connected to
the unit. This may cause damage to the speakers.
1
Turn the M.C. dial to select the options, then press to confirm.
To proceed to the next menu option, you need to confirm your selection.
RESET button
- 5 - - 5 -