Citrix ADC SDX Bedienungsanleitung Seite 124

Citrix ADC SDX
Die Seriennummer kann hilfreich sein, wenn Sie den technischen Support von Citrix kontaktieren
möchten.
1 3. Führen Sie den folgenden Befehl
Schnittstellen
2 Schnittstelle anzeigen
Beispiel
1 show interface
2 1) Interface
3 flags=0xc020
4 MTU=1500,
5 Requested:
6
7 Actual:
8 LLDP
9 RX: Pkts(44337150) Bytes(2767558041) Errs(0) Drops(41260552)
10 TX: Pkts(128116) Bytes(9004699) Errs(0) Drops(0) Stalls(0)
11 NIC: InDisc(0) OutDisc(0) Fctls(0) Stalls(0) Hangs(0) Muted(0)
12 Bandwidth thresholds are not
13 2) Interface
14 flags=0x4000
15 MTU=1500,
16 Requested:
17
18 LLDP
19 RX: Pkts(0) Bytes(0) Errs(0) Drops(0) Stalls(0)
20 TX: Pkts(0) Bytes(0) Errs(0) Drops(0) Stalls(0)
21 NIC: InDisc(0) OutDisc(0) Fctls(0) Stalls(0) Hangs(0) Muted(0)
22 Bandwidth thresholds are not
23 3) Interface
24 flags=0x4000
25 MTU=1500,
26 Requested:
27
28 LLDP
29 RX: Pkts(0) Bytes(0) Errs(0) Drops(0) Stalls(0)
© 1999-2019 Citrix Systems, Inc. All rights reserved.
anzuzeigen:
0/1 (Gig Ethernet
<ENABLED, UP, UP, autoneg, HAMON, 802.1q>
native vlan=1, MAC=0c:c4:7a:41:ea:94,
h59m55s
media AUTO,
throughput
media UTP, speed
throughput 1000
Mode: NONE
Stalls(0)
0/2 (Gig Ethernet
<ENABLED, DOWN, down, autoneg, HAMON,
;
native vlan=1, MAC=0c:c4:7a:41:ea:95,
h00m08s
media AUTO,
throughput 0
Mode: NONE
10/1 (10G
<ENABLED, DOWN, down, autoneg, HAMON,
;
native vlan=1, MAC=68:05:ca:30:e1:40,
h00m08s
media AUTO,
throughput 0
Mode: NONE
aus, um den Status der aktiven
10/100/1000 MBits) #10
speed AUTO, duplex
0
1000, duplex
set.
10/100/1000 MBits) #11
speed AUTO, duplex
set.
Ethernet) #17
speed AUTO, duplex
uptime
AUTO, fctl OFF,
FULL, fctl OFF,
downtime
AUTO, fctl OFF,
downtime
AUTO, fctl OFF,
43
802.1q&gt
44
802.1q&gt
44
124