Specifications - Polaroid XS100 Benutzerhandbuch

POLAROID XS100 USER GUIDE

Specifications

Optics
1 /2.5" 5MP CMOS Image Sensor
F2.8 Fixed Focus Ultra Sharp Glass Lens
Light Sensitivity: >1.4 V/lux-sec
Dynamic Range: >65db
White Balance, ISO, Scene: Auto
Exposure Auto Control: Auto
170 Degree Ultra Wide Angle Lens
File Format: Video- H.264 MPEG4, PHOTO- JPEG
Video (NTSC/PAL)
HD Resolutions
*1080p: 1920x1080p / 30FPS / 16:9
*960p: 1280X960P / 30FPS / 4:3
*720p:1280x720 / 60FPS (Slow Motion) / 16:9
*720p: 1280x720 / 30FPS/ 16:9
Photo:
Resolutions 16MP , 5MP , 3MP , VGA
Photo Mode: Single / Burst (x10) / Time Lapse (5,10,30,60)
Microphone /Audio
Mono, 48 KHZ, AGC Compression, auto gain control
Audio Format: ADPCM
Storage/Recording Time
32MB internal Memory
Micro SD – Up To 32GB
Battery/Charging
1200MAH Built In Battery (Approx. 2.5 hrs of Use)
Other
G-Sensor (Auto Rotation): Yes
Auto Power Off: off/1min / 3min
Dual File Recording: Yes
Vibrates: Yes
Anti-Shake: Yes
20
Inputs/Outputs
USB 2.0, HDMI
Housing
IPX8: Waterproof Up To 10Meter
Metallic & Crystal Clear Finishing
High Impact & Shock Proof
Operating System
Windows 7/XP SP3 /Vista and later, Mac 10.5 or above
Size: 108*42*42.4mm
Weight: 4.8oz
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in Subpart
B of Part 15 of the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or
modifications should be made, you could be required to stop operation of the equipment.
POLAROID XS100 USER GUIDE
21