Velleman CAMSETBP2 Bedienungsanleitung

CAMSETBP2 – BATTERY PACK FOR CAMSETW11N MONITOR
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the CAMSETBP2! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
The CAMSETBP2 is for use with the monitor of the CAMSETW11N (sold separately) only. Remember not to use this
battery pack in wet conditions.
2. Contents
1) 1 x rechargeable battery pack
2) This manual
3. Charging the Battery Pack
IMPORTANT: Charge the battery for 24 hours before first use.
• Connect the adapter (supplied with the CAMSETW11N) to the battery pack through the DC input at the back of
the battery pack. Connect the battery pack to the monitor. A red LED on top of the battery pack indicates the
charging process.
• Connect the adapter to the mains. Only use the appropriate adapter!
Make sure the monitor is switched OFF when charging for the first time.
After the initial charging process, the CAMSETBP2 will trickle charge whenever the adapter is plugged in. Switch off
the battery pack when the battery pack is not being used to power the monitor.
4. Battery Installation (fig. 1)
CAMSETBP2
- 1 - VELLEMAN