Herunterladen Diese Seite drucken

Troubleshooting - Ergotron VL Enclosure Benutzerhandbuch

Werbung

English
8
4x
Ensure that the batteries are installed in the battery pack.
NOTE: User should change Master Code upon receipt of Enclosure.
Programming New Codes
1
Enter Master Code on Keypad.
2
Numbers 3 and 5 on the Keypad will start fl ashing, indicating the Master Code has been accepted.
3
Simultaneously press 3 and 5 while they are fl ashing.
4
All the numbers will light (you have 3 seconds to enter a code).
5
Enter a new code—any sequence of 5 numbers. (The fi rst code programmed is the new Master Code.)
6
When the code is accepted, all of the LEDs will fl ash once in acknowledgement (you have 3 seconds to enter the next code).
7
You can then proceed to program up to 10 personal codes by repeating steps 5 and 6.
8
When fi nished entering new codes, system will exit program mode after 3 seconds with a series of LED fl ashes.
Unlock (3 methods):
• Enter Master Code.
• Enter Personal Code.
• Key - turn counter clockwise 1/8 turn
Lost Master Code
Contact Ergotron Customer Care for instructions.

Troubleshooting

• Key pad numbers are dark
-Touch anywhere on number pad to activate back-light, (remains locked
until you enter valid code)
-Check to make sure battery pack is connected
• Code is accepted but does not open
-make sure door is fully closed and lock engaged before entering code
• Door won't open when Personal Code is entered
-Test system by entering Master Code. If door doesn't unlock, follow
"Lost Master Code" instructions.
888-60-506-W-03 rev. E • 09/09
(Default Master Code: 12345)
Lock (2 methods):
• Wait 4 seconds to lock automatically
• Press 1 and 2 on number pad simultaneously
Erase All Codes (cannot erase only one code):
1 Enter Master Code
2 Press 3 and 5 simultaneously (while blinking)
3 Press 1 and 2 on number pad at the same time
4 Follow "Lost Master Code" instructions to reset to
the default Master Code
1
Flashing LED: Meaning
1: Door is open
3 & 5: Unit is ready to program master or user codes (see Programming New Codes)
5: Door is unlocked
All: New code accepted
Guía del usuario - Español
Manuel de l'utilisateur - Français
Gebruikersgids - Nederlands
Benutzerhandbuch - Deutsch
Guida per l'utente - Italiano
ユーザーガイ ド : 日本語
用户指南 : 汉语
사용자 안내서 : 대한민국
2
3
1x
11/20

Werbung

loading

Verwandte Produkte für Ergotron VL Enclosure

Diese Anleitung auch für:

Styleview vl enclosureStyleview vl