Technical Specifications - Perel Tools GIK10 Bedienungsanleitung

• Unplug the device from the mains.
• Use a screwdriver with an insulated handle. Make sure you only hold the screwdriver by the handle.
• Short-circuit the 2 wires of the inner metal grid by gently touching them simultaneously with the
metal shaft of the screwdriver. A spark may arise. Repeat this manipulation until no more sparks
arise.
c. Cleaning the device
• Clean the insect killer regularly with a dry, clean cloth and plastic brush.
Do not submerge into any liquid.
• Make sure no dust accumulates on the LEDs as this will greatly reduce
their effectiveness.
• Discharge the device.
• Remove the plastic grid:
push on the top lid of the grid (see arrow) and pull.
• Only use a plastic brush to clean the high-voltage grid. Brush gently to
avoid damage.
• Place the plastic front grid back. Insert the bottom protrusion in the
notch and click the grid in place.
d. Maintenance
• All screws should be tightened and free of corrosion.
• The housing and its accessories should not be deformed.

5. Technical specifications

input voltage
grid voltage
effective area
lamp
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide
rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any
electronic medium or otherwise without the prior written consent of the copyright holder.
12.11.2009
GIK10
230VAC / 50Hz
800-1000V
50m²
4 x water clear 5mm UV LEDs
255 x 230 x 85mm
975g
3
©Velleman nv