MotoramaJr Baby car fiat 500 R/C Anleitung Seite 7

1. Ensure that the ON/OFF switch is in the OFF position.
2. First take off the seat pushing the seat button position on the back side of the seat
(Figure 1) and at the same time, pull the seat up to open it.
3. Split off the connector between rechargeable battery and the socket of PCB board as
shown (Figure 2).
4. Connect the connector of battery and charger, red light on the charger light up, start
charging . Stop recharge after 8-12 hours. (Figure 3). (Please make sure the voltage is
accordant with the one marked on charger).
5. Connect the battery cable line with the socket of PC board, put on the seat (Figure 4).
6. Push down the seat to fix the seat tightly. Push button means loose, loose button means
locked (Figure 5).
Attention! The vehicle cannot be used when during recharging, please turn off the general
power. Use only the charger supplied to recharge the battery. The battery become warm
during charge. Do not overcharge the battery. Do not keep in charge more than 16 hours
each time. For best result ensure that battery is only recharged after the life is fully
exhausted. Recharge the vehicle to avoid battery damage (1 recharge every 12 months at
least). Battery recharge must be carried out by an adult. During recharge don't press the
electric pedal.
INSTRUCTIONS FOR USE
The key on the right part of the dashboard (4) is the general switch of power supply. Turn
the key clockwise key to start the vehicle: a motor sound indicates that the vehicle is
ready. Press the accelerator pedal (3) or use the transmitter to activate the vehicle's driving
wheels. To turn the vehicle off, turn the key counterclockwise.
WORKING WITH TRANSMITTER
A. FORWARD/BACK
B. LEFT/RIGHT
Press the button C to ON position to activate the transmitter. Insert the key and turn
clockwise (4). To make the vehicle move back/forward (A) and turn left/right (B) press the
buttons as shown in the pictures. In order to turn the vehicle left/right pay attention to
push both the buttons (A and B).
WORKING WITH PEDAL: Turn right the key. Push the handle switch on the right of the
dashboard (5) on the "forward" or "backward" position. To stop the vehicle release the
pedal. Move the handle switch in the middle position in order to stop the vehicle.
HORN (2): push the button to start-up sounds.
FRONT LAMP SWITCHES (1): push the button to turn on the frontal lights. The rear
lights turn on when the vehicle moves backward.
C. ON/OFF