Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Glamox UW-SEN
Glamox UW-SEN is a wireless 2-channal sensorsystem, which
means that all luminaires serve as both masters and slaves. As a
slave the UW-SEN can listen to 2 masters / channels.
All you need to do is to set the channel you transferring on (master
channel) and the two channels you are receiving on (slave channels).
When presence is detected, a light-on activation signal is sent on
the master channel. All sensors that has set that channel as a slave
(receiver) channel will then be activated.
The 5,8 GHz signal from the sensor penetrates lightweight walls and
windows. NOTE: When wall mounted the microwave signal detect
movement several meters horizontally.
To set the master and slave channels.
Both slave and master can be set to 16 different channels
(Hexadecimal setting).
2
5
4
3
2
1
Slave channel
Master channel
Typically in a 7-floor staircase
the following settings can be used.
Floor
Master channel
Ground
0
1
1
2
2
3
3
4
4
5
5
6
6
Other settings
Detection area
Reduction of sensitivity will narrow the detection area.
The following settings are available.
5
4
Hold time
Determines the time the fitting remains ON after last detection of
3
motion. The following settings are available.
2
10
20
1
Daylight sensor
Determines the lux-level when the luminaire shall be turned off
because of sufficient daylight. Recommended to put to "Photocell
Disabled" because of internal light reflection inside the luminaire.
Stand-by dim level (1-10 V)
10%
20%
30%
50%
English
Slave channel 1
Slave channel 2
1
1
0
2
1
3
2
4
3
5
4
6
5
7
*
10
20
*
10%
20%
30%
50%
* Factory setting
** Factory setting A40
Werbung
