parktool PRS-33TT Anleitung

PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
1
3
PRS-33TT Tool Tray
Hook Assembly
1. Remove one M8 nut from the hook and slide into the bottom T-track of the
extrusion.
2. Thread the end of the hook into the M8 nut in the T-track so that the
other M8 nut and the washer are on the outside of the T-track, as shown.
Thread until just before the hook stops threading.
3. Slide the hook in the desired location and tighten the lower M8 nut with a
wrench.
Bracket Mounting Hardware Assembly
Assemble the three sets of M8 screws, washers, and T-nuts onto the
mounting bracket as shown. Leave loose.
Removing The Top Cross Bar from the PRS-33
1. Loosen (but do not fully remove) the two M6 screws on the mounting
brackets as shown (four M6 screws total).
PRS-33TT
Instructions / Instructions / Anleitung / Instrucciones
STEP 3
2
4
2. Lift the entire top cross bar from the main upright, turn it 90 degrees from
its original position and set it back on top of the main upright. This will
leave the proper opening in the T-track of the main upright to slide the
PRS-33TT down into position.
3. Manually hold the top cross bar in position.
Installing the PRS-33TT
1. The PRS-33TT is designed to be installed on the right side of the PRS-33
clamp (when looking at the PRS-33).
2. While holding the top cross bar, slide the T-nuts on the PRS-33TT into
the PRS-33 main upright T-track.
3. Slide the PRS-33TT down to desired position and tighten the three M8
screws.
Re-assembling the Top Cross Bar on the PRS-33
Place the top cross bar back in its original position and tighten down the four
M6 screws.
STEP 2