Velleman components VDL215EQ Bedienungsanleitung

VDL215EQ – DUAL 15-BAND GRAPHIC EQUALIZER
1. Introduction
Thank you for buying the VDL215EQ! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
• Damage caused by disregard of the guidelines in this manual or by user modifications is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is designed for professional use in discos, theatres, etc. The VDL215EQ should only be used indoors,
connected to an alternating current of max. 230V AC/50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Install the device where it is protected against extreme heat (see "7. Technical Specifications"), dust and moisture.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
4. Installation
• The VDL215EQ is designed to be mounted in a standard 19" equipment rack or in a portable case.
• Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
5. Commands and Connectors
a. Front Panel - Commands
1. EQ level controls
2. EQ on/off button
3. EQ Range selection (6/12dB)
4. Low cut button (sets 30Hz to -6dB)
5. Channel level control
6. Peak indicator (red LED): lower the level (#5) if this LED remains lit continuously.
7. On/off switch
VDL215EQ
Fig.1
1 VELLEMAN