Installation; Tools Required; Cable Requirements; Housing Mounting - Bosch HSG9583 Serie Bedienungshandbuch

HSG9583 Series | Instruction Manual | Installation
4

INSTALLATION

CAUTION: These units must be properly
and securely mounted to a supporting
structure capable of sustaining the unit
weight. Use care when selecting mounts or
pan/tilts (not supplied) for installation; the
mounting surface and unit's weight should be
carefully considered.
4.1

Tools Required

• Small flat blade screwdriver
• Phillips screwdriver (#1)
• Adjustable wrench
• Wire cutter/stripper/crimper tool
4.2

Cable Requirements

Video Transmission (Coaxial)
Cable Type: RG-59/U for runs < 300m (1000ft)
RG-11/U for runs < 600m (2000ft)
Cable Size: Outside diameter between
4.6mm (0.181in)-7.9mm (0.312in)
Cable Shape: Round
Shield: > 93% Braided copper shield
Center Conductor: Stranded copper center
DC Resistance: < 15Ω/1000 (RG-59/U)
< 6Ω/1000 (RG-11/U)
Cable Impedence: 75Ω
Agency Rating: UL
Environmental: Outdoor rated
Temperature Rating: > 80°C
Sources: Belden 9259
Input Power Cord - North American
Cable Type: SJTOW rated
Cable Size: Outside diameter between
4.3mm (0.170in)-11.9mm (0.470in)
Cable Shape: Round
Conductors: 3-conductor version and
2-conductor version
Agency Rating: UL/C.S.A., UL VW-1
Environmental: Outdoor rated
Temperature Rating: 105°C
Voltage Rating: 300 V
Sources: Belden 19509, 3-conductor
Northwire FSJT183-81K, 3-conductor
Bosch Security Systems | 12 August 2005
Input Power Cord - European
Cable Type: H05RN-F 3 G 0.75 and
H05RN-F 3 G 1.00
Cable Size: Outside diameter between
4.3mm (0.170in)-11.9mm (0.470in)
Cable Shape: Round
Conductors: 3-conductor version and
2-conductor version
Agency Rating: VDE
Environmental: Outdoor rated
Sources: Olflex rubber cable 1600 252
Olflex rubber cable 1600 253
Lens Control Cable
Cable Type: Jacketed multiconductor cable
Cable Size: Outside diameter between
4.3mm (0.170in)-11.9mm (0.470in)
Cable Shape: Round
Shield: Overall shielding
Conductors: Stranded 20 to 16AWG wire
No. of Conductors: 4 and 8
Conductor Insulation: Color coded
Sources: Belden 9552, 4-conductor
Belden 9554, 8-conductor
4.3

Housing Mounting

1. Use the two 1/4-20 x 0.50in. screws and
1/4in. spring washers provided in the hardware
kit to mount the housing to a mount or a
pan/tilt. The spring washers must be used for
the screws to thread properly.
2. The outermost set of 1/4-20 threaded holes are
for mounting to feed-through mounts and the
innermost 1/4-20 holes are for mounting to all
other mounts and pan/tilts.
4.4

Opening the Cover

1. Open the cover by unlatching the two clasps
on the side of the housing (see FIGURE 1).
Figure 1: Unlatching the Cover
NOTE: If the optional tamper-resistant screws have
been installed, use the supplied wrench to
remove the screws before opening the latches.
EN | 6