Introduction & Features; Safety Instructions; Operation - Velleman VTUSCT Bedienungsanleitung

VTUSCT – ULTRASONIC CLEANER WITH TIMER
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VTUSCT! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
The ultrasonic cleaner generates numerous micro bubbles which will clean hard-to-reach places. Together with some
detergent, this is a very effective way to clean jewellery, dentures, eyeglasses, printer heads, etc.

2. Safety Instructions

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Remove the water from the tank after each use to prevent corrosion.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Never operate the device without water in the tank.
• Never operate the device for more than one hour at a time.
• Put the device on a flat surface and keep the area around it clean and dry.
• Use the original packaging if the device is to be transported.
• Do not shake the device.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.

3. Operation

1. Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
2. Put the object into the tank and fill the tank up to the MAX marking with water. However, make sure the object is
completely submerged. Add some detergent if needed. Close the lid.
3. Programming the VTUSCT:
• Put the plug into the mains. The display will show HI. Press the ON/OFF button to start the cleaning process
without timer.
• Press the timer button to enter a timed cleaning process. Press repeatedly to enter the desired time (from 3 to
59 minutes). When the cleaning process is finished, the display will go out and the device will turn off.
NOTE: It is normal to hear some buzzing.
• Remove the plug from the mains after use.
VTUSCT 2 VELLEMAN