Velleman VASDAC2 Bedienungsanleitung Seite 5

6. Installation
Refer to the illustrations on page 2 of this manual.
Caution: Before installation, switch off all audio/video
devices and unplug the power adapter of the converter.
Switch on all devices after all the connections are made.
1. Choose your input type:
o COAXIAL: if you use an S/PDIF coaxial cable (not incl.)
o OPTICAL: if you use a Toslink
Notes: Toslink
and do not bend. Do not touch the optical fibre ends of
the cable while you make the connections. Use only one
type of input cable at the same time. Do not use Toslink
and S/PDIF coaxial cables together.
2. Connect the cable to the correct input:
o Connect the Toslink
connect the other end to the Toslink
audio/video device [7].
o Connect the coax cable to the coaxial input [2] and connect the
other end to the audio output of your audio/video device [8].
3. Connect the RCA cable (incl.) to the RCA audio outputs [4, 5]
(white RCA plug in the white jack; red RCA plug in the red jack)
and connect the other end of the cable to your amplifier [9].
4. Connect the power adapter (incl.) to the DC jack [6] and plug
the other end into a suitable power outlet. The power indicator
[3] lights.
5. Switch on all connected audio/video devices.
V. 01 – 14/12/2016
VASDAC2
® cable (not incl.).
® fibre cable is fragile, handle with care
® cable to the Toslink
5
® input [1] and
® output of your
©Velleman nv
®