Use Recommendations - Gemini 810 + 980 DIODE LASER Bedienungsanleitung

EN
Note: The Pain Relief preset procedure is only available
on 810 nm Wavelength mode.
To use the Pain Relief presetting:
1. Make sure the laser is in 810 nm wavelength mode
2. Navigate to Pain Relief in the preset procedure menu
3. The numbers on the display will begin to blink,
prompting the selection of treatment time
4. Use the right and left arrows to adjust the desired
treatment time in 3-second increments, with a
maximum treatment time of 60 seconds
5. Touch the Active button to lock in the treatment time
and activate the laser system
6. The laser is now ready for treatment. Depress the foot
pedal to fire the laser. Keep the foot pedal depressed
throughout the duration of the treatment. The laser
will automatically stop firing and return to Standby
mode when the timer expires.
7. The timer reverts to the previously selected treatment
time in Standby mode. To proceed to the next
treatment, adjust the treatment time as needed and
then press the Active button.

5. USE RECOMMENDATIONS

The intended use of the PBM Adapter is to allow the
Gemini Laser to provide near-infrared laser energy to a
tissue surface for the purpose of photobiomodulation.
Affected muscles and/or joints have to be exposed to
an adequate level of laser energy over a period of time
to provide effective results. Some cases may require
more than one laser treatment, or a series of treatments,
before significant improvement is reported. Repeat the