Replace The Lamp - Perel WTL7 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the WTL7! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.

2. Replace the Lamp

Unplug the device and let the circular fluorescent lamp cool down before replacing it.
The lamp is located behind a plastic diffuser and is held in place by six plastic clamps.
1. Remove the 10 screws that hold the plastic diffuser in place and gently remove the diffuser.
2. Carefully take the defective lamp from the clamps and the connector and remove it.
3. Install a new lamp (order code WTL7/SP1) by connecting it and securing it in the plastic clamps and the
connector.
4. Put the diffuser back and fasten its screws.
3. Beware
• Never leave the magnifying lens unattended where direct sunlight may pass through it: this creates a fire hazard.
• Use the lamp only indoors.
• If the power cable is damaged, have it replaced by your dealer.
• The only user-serviceable part is the lamp. Have a qualified person service the device should it become defective.
For more info concerning this product, please visit our website www.velleman.eu
The information in this manual is subject to change without prior notice.
WTL7
WTL7 – LAMP WITH MAGNIFYING GLASS
3 VELLEMAN