Clean Air Optima AD-302 Gebrauchsanweisung Seite 7

• Press the on/off button once, the continuous mist mode will be switched on.
• Press the on/off button again, the device will switch to the intermittent mist mode.
Press one more time, the device will return to the standby mode.
• Press the light button, the yellow light is on. Press again, the device will alternate between
seven colours. Press one more time, the present colour is frozen. Press again to switch off
the light.
Note: When the water runs out (water level lower than the water sensor), the evaporation
will stop. The device flashes red five times to indicate that the water level is too low.
The device will switch to standby mode.
Attention
1. The device must use the correct power supply.
2. Do not pour water on the mist outlet directly, or it will damage the product.
3. The mist plume can differ per device, which is normal because it depends on various
factors such as type of water, humidity, temperature and air flow.
4. If water shortage occurs while the device is switched on, the device will light up red five
times. In that case, the device cannot spray mist but the light function will continue to work.
5. Do not use corrosive liquids, otherwise it will damage the device.
6. When using or changing to a different essential oil, please make sure to follow the
instructions in the "maintenance" section.
Accidentally leaking
If the device is accidentally knocked over or dropped while using, please proceed as follows:
1. Switch off and pull the power cord out of the device.
2. Empty the remaining water. (Do NOT pour out from the mist outlet side, to avoid water
getting in the circuit board, see picture below).
Air Outlet
7