Parts Description; Installation And Connection - Kiwi kmo-4240 Bedienungsanleitung

• Consult a qualified electrician or serviceman if the grounding instructions are not completely understood or if doubt
exists as to whether the appliance is properly grounded. If it is necessary to use an extension cord , use only a 3-wire
extension cord.
• A short power-supply cord is provided to reduce the risks resulting EN from becoming entangled in or tripping over
a longer cord.
• If a long cord set or extension cord is used the marked electrical rating of the cord set or extension cord should be
at least as great as the electrical rating of the appliance.
• The long cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled
on by children or tripped over unintentionally.
Which materials are not suitable for placing in the microwave?
Not all materials can be placed in a microwave. Below shows which materials are not suitable:
• Cookware made of porcelain and ceramics
• Non-heat-resistant bowls
• Metal bowls
• Metal racks
• Aluminium foil
• Şammable material such as plastic, paper, plastic, textile, wood, şowers or other şammable material.
• The packaging of sealed packaged foods can easily burst, which may cause fire.
• Keep warm packages. These can be ignited.
• Metal locking strips
• Pillows filled with grain, cherry pits or gel.
• Sealed bowls and eggs. Eggs may burst due to the pressure.
If you're not sure, you can test the material in question by following the procedure below.
1. Fill a microwave-safe container with 1 cup of cold water (250ml) along with the utensil in question.
2. Cook on maximum power for 1 minute.
3. Carefully feel the utensil. If the empty utensil is warm, do not use it for microwave cooking.
4. Do not exceed 1 minute cooking time.

PARTS DESCRIPTION

1. Control panel
2. Turntable shaft
3. Turntable ring assembly
4. Turntable Glass tray
5. Observation window
6. Door assembly
7. Safety interlock system
8. Control lever
9. Timer
10. Open key

INSTALLATION AND CONNECTION

• Remove all packing material and accessories. Examine the oven for any damage such as dents or a broken door. Do
not install if the oven is damaged.
• Remove any protective film, found on the microwave oven cabinet surface.
• Do not remove the light brown Mica cover that is attached to the oven cavity to protect the magnetron.
• Select a level surface that provide enough open space for the intake and/or outlet vents.
• The rear surface of appliance shall be placed against a wall. A minimum clearance of 7.5cm is required between the
oven and any adjacent walls. One side must be open. Leave a minimum clearance of 30cm above the oven. Do not
remove the feet from the bottom of the oven.
• Blocking the intake and/or outlet openings can damage the oven.
• Place the oven as far away from radios and TV as possible. Operation of microwave oven may cause interference to
your radio or TV reception.
• Plug your oven into a standard household outlet. Be sure the voltage and the frequency is the same as the voltage
and the frequency on the rating label.
• Do not install the oven over a stove or other heat-producing appliance.
If installed near or over a heat source, the oven could be damaged and the warranty would be void.
1
9
8
10
5 7 6
5
KMO 4240 User Manual
4 3 2