D-Using Your Cooler; Start-Up; Setting Internal Temperature Of Your Product - Ugur USS 100 SC Bedienungsanleitung

D-USING YOUR COOLER

Start-up

WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up (see page 19).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running your cooler. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 8)
• You will hear a slight sound from the compressor when your product is running.
Picture 8

Setting internal temperature of your product

Internal temperature of your product is set in the factory in a manner that allows protection of your foodstuff stored
in the device under any condition.
Thermostat of your product is located in the compressor section and it can be set to the desired temperature only by
the Authorized Uğur Service if requested (except models with digital thermostat)
When you operate your product under the factory set value, you get the best result in terms of both performance and
energy consumption.
Run your device empty for at least two (2) hours so that inside of your product will be cooled in best way in all aspects.
43
EN