Battery Installation - Beper 50.240 Betriebsanleitung

Lint Remover Use instructions
CHILDREN SHOULD BE SUPERVISED TO ENSURE
THAT THEY DO NOT PLAY WITH THE APPLIANCE.
KEEP CHILDREN WELL AWAY FROM PACKAGING
MATERIALS, AS THERE IS A POTENTIAL SOURCE
OF DANGER E.G. FROM SUFFOCATION.
No responsibility will be accepted if damage results from improper
use, or if these instructions are not complied with.
This appliance is intended for domestic use only and not for commer-
cial applications.
In order to comply with safety regulations and to avoid hazards, re-
pairs of electrical appliances must be carried out by qualified per-
sonnel. If repairs are needed, please send the appliance to one of
our customer service departments. The address can be found in the
appendix to this manual.
PRODUCT DESCRIPTION Fig.1
1. Protective cover
2. Suction grille with frontal ferrule
3. Rotating blades
4. Rotation pin
5. Ergonomic housing
6. On-/Off switch
7. Lint container
8. Battery cover

BATTERY INSTALLATION

Remove the battery cover by pull it down.
Insert 2xAA alkaline batteries in the battery compartment following the battery direction sign as imprinted.
Close the battery cover until the cover clicks into place and locks.
INSTRUCTIONS FOR USE Fig.A
The lint remover must be used to remove unsightly hair, lint and wool balls from skirts, sweaters, jackets, trou-
sers, blankets or other clothing in general.
Warning: do not remove the lint directly from the garments while wearing.
Pay attention to buttons, zips, signs, stitching and other elements in the garment.
It is advisable to make a test by passing the lint remover into invisible parts of the garment.
Press the ON / OFF operation button.
Gently wipe the lint remover on the surface of the garments one or more times until completely smoothed.
Once the operation is completed, switch off the lint remover by pressing the ON / OFF switch and reposition the
protective cover.
If the fabric is very light, it is advisable to fold it into two parts before removing the lint.
The product is equipped with a safety system that will not let operate the product if the ferrule is not positioned
correctly.
N.B. It is advisable to pass the lint remover on the fabrics by following the weave of the fabric itself.
LINT REMOVER CLEANING Fig. B-C
Before cleaning the lint remover make sure it is turned off.
Remove the suction grille with the frontal ferrule by turning anti-clockwise.
Remove the rotating blades very carefully, as they are sharp.
Clean the rotating blades and the back of the suction grille by using the special brush supplied.
8