Operation; Cleaning, Care & Maintenance - Polar Refrigeration GH268 Bedienungsanleitung

UK
Ventilation
• Locate the appliance in a dry place.
• Protect against direct exposure to sunlight
and sources of heat or draughts including
air currents such as radiators, fans, air
conditioning units and doors, etc.
• Install the appliance in a place with good
natural ventilation to increase ventilation
properties.
• Multidecks generate a considerable amount of
heat and, if operated in a small unventilated
room will quickly cause the room temperature
to become excessive. This could cause the
motor to overheat and possibly damage
the compressor. At the very least, such an
installation will cause the unit to use an
excessive amount of electricity.
• Poor ventilation / excessive heat can cause the
multideck to produce excessive condensation.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects
for ventilation. Increase this distance if the
obstacle is a heat source.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.

Operation

Control Panel
A B
A - Lamp Switch
B - Power Switch
C - Controller
4
GH268_GH269 _ML_A5_v4_170424.indb 4
Turn On
1. Ensure the power switch B is set to [O] and
turn on at the socket.
2. Switch on the power switch [I]. The current
temperature within the appliance is displayed.
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for
2 seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
Cleaning the Condenser
• Periodically cleaning the condenser can extend
the life of the appliance.
• The condenser is located behind the front
bottom panel.
C
or buttons to display the
Switch off and disconnect
from the power supply before
cleaning.
Note: Use a soft brush or
vacuum cleaner to clean the fins
of the condenser, taking care
not to damage the fins.
2017/4/24 10:17