Before Initial Use; Using Accessories Correctly - Kiwi KMC 6940 Bedienungsanleitung

Before Initial Use

1. Remove any protective films and stickers that may be present from the device.
2. The accessories may still have some production residues on them. To avoid harmful
effects to your health, clean the device thoroughly before you first use it (see
"Cleaning and Storage").
3. Familiarise yourself with the accessories. Do this by reading the following chapter.

Using Accessories Correctly

Cross-Blade Attachment

ATTENTION!
• Risk of damage to the cross-blade attachment! Do not drop the cross-blade
attachment and do not leave it lying in water or other liquids for longer than two hours
to avoid damage.
The cross-blade attachment is used to chop up, stir and mix together the ingredients in
the mixing bowl.
The device cannot be operated without the cross-blade attachment.
Inserting:
1. Before inserting the cross-blade attachment, ensure that the sealing ring is
fitted correctly on the shank of the attachment. Otherwise there is the risk that
liquid will escape from the mixing bowl into the motor unit and the device will be
damaged.
If the sealing ring is not fitted correctly, slide it all the way onto the shank until it is
firmly fixed behind the two latches on the shank.
2. Hold the cross-blade attachment at the top end
and place it in the mixing bowl. Make sure that the
cross-blade attachment rests fully on the bottom of
the mixing bowl. The two locking lugs on the shank
must be pushed through the recesses in the mixing
bowl.
3. Hold the cross-blade attachment firmly, turn the
mixing bowl upside down and place the wing nut on
the end of the shank. It must be fully recessed. If
necessary, twist the wing nut slightly to do this.
33
KMC 6940 User Manual