Cutter Deck Adjustments; Cutter Deck Tension - Textron LQ Serie Wartungsanleitung Und Stückliste

7

CUTTER DECK ADJUSTMENTS

GB
CUTTER DECK ADJUSTMENTS
7.1 CUTTER DECK BELT TENSION
Check all belts regularly during the first 5, 10 and 15
hours of operation, and then after every 50 hours of
operation. If necessary adjust as follows:
CENTER DECK
1. Adjust belt tension to 1/2" (13 mm) deflection at
10 lbs (5 kg) force at the middle of the long rear
span D. If necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt E.
3. Loosen (4) bolts G fastening the motor mounting
plate to the cutter deck (3 visible in photo).
4. Turn adjustment bolt E until proper tension is
obtained.
5. Retighten (4) bolts G and lock nut on adjust-
ment bolt E.
WING DECKS
1. Adjust belt tension to 3/8" (10 mm) deflection at
10 lbs (5 kg) force at the middle of the long rear
span H. If necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt L.
3. Loosen two bolts I fastening the idler plate to
the cutter deck.
4. Turn adjustment bolt L until proper tension is
obtained.
5. Retighten bolts I and lock nut on adjustment
bolt L.
GB-18
FRONTLINE 960 Series: LQ
MAINTENANCE AND PARTS MANUAL