Dover Hydro CP-500 Kurzanleitung

WARNING Please read precautions thoroughly before operation. Meet all applicable local codes and regulations.
WEAR protective clothing and eyewear when dispensing chemicals or other materials or when working in the vicinity
of all chemicals, filling or emptying equipment, or changing metering tips.
ALWAYS observe safety and handling instructions of the chemical manufacturer.
direct discharge away from you or other persons or into approved containers.
dispense cleaners and chemicals in accordance with manufacturer's instructions. Exercise CAUTION when
maintaining your equipment.
reassemble equipment according to instruction procedures. Be sure all components are firmly screwed or
latched into position.
KEEP equipment clean to maintain proper operation.
introduction
Package Contents
CP-500 Warewash Dispenser (part number varies by model)
• CP-500 Dispenser (Part number varies by model)
• Quick Start Guide (P/N HYD10099215)
• Accessory Kit: Mounting bracket, fittings, hardware, and pickup tubing
(Part number varies by model)
• Pump Squeeze Tube (not installed)
• Detergent models use Santoprene® tubes as standard
• Rinse models use silicone tubes as standard
• (Part number varies by model)
Operation
The CP-500 is a globally versatile, single product dispenser used to supply detergents or rinse aid into automatic dish machines. Designed
with simplicity in mind, the unit can be installed in minutes and requires no programming; all settings can be configured using potentiometers
that control the time or speed of dosing (depending on the model). The unit has the reliability and accuracy you expect from Hydro Systems
Co. at an economic price point.
NOTE! The CP-500 is intended for use in industrial applications. It is not suitable for domestic use, and it must not be used outside of its
intended use. The product must only be used for commercial dish washing operations. The manufacturer waives any responsibility arising
from incorrect usage or transportation.
General Specifications
Category
Electrical
Chemical Temperature Rating
Regulatory Approvals (CE)
Cabinet Material
Environmental
Dimensions
quick start guide
CP-5OO Warewash Dispenser
THANK YOU FOR YOUR INTEREST IN OUR PRODUCTS
Please use this equipment carefully and observe all warnings and cautions.
Specification
90 to 260 VAC at 50/60Hz
Intake chemicals should be at room temperature
(Regarding "Electromagnetic Compatibility" and the subsequent
89/336/CEE
modifications to 92/31/CEE, 93/68/CEE, 93/97/CEE)
(Regarding "Low Voltages", and the subsequent modifications to
73/23/CEE 93/68/CEE, 2002/95/CE, 2002/96/CE, 2003/108/CE "RoHs and
WEEE Directive")
Front: Polypropylene - Rear: Polypropylene
Pollution: Degree 2, Temperature: 50°to 104° F (10° to 40° C), Maximum Humidity: 95% Relative
5.0 in (128 mm) High x 3.6 in (91 mm) Wide x 4.1 in (104 mm) Depth