FanWorld FW6 Serie Bedienungsanleitung Und Installationshandbuch Seite 45

Stop the air conditioner immediately if one of the following faults occur. Disconnect the
power and contact the nearest customer service center.
If the E( 0,1.......) or P( 0, 1 .......) code appears on the LED(LCD)window, disconnect the
power and contact the service people.
Trouble
Fuse blows frequently or circuit breaker trips frequently.
Other objects or water penetrate the air conditioner.
The remote controller won't work or works abnormally.
Other abnormal situations.
Malfunctions
Unit does not Power cut
start
Unit may have become unplugged.
Fuse may have blown.
Battery in Remote controller may have
been exhausted.
The time you have set with timer is
incorrect.
Unit not cooling
Inappropriate temperature
or heating
setting.
(Cooling/ heating
models only)
Air filter is blocked.
room very well
while air flowing Doors or Windows are open.
out from the air
Air inlet or outlet of indoor or
conditioner
outdoor unit has been blocked.
Compressor 3 minutes
protection has been activated.
If the trouble has not been corrected, please contact a local dealer or the nearest customer
service center. Be sure to inform them of the detailed malfunctions and unit model.
Notes: Do not attempt to repair the unit yourself.
Always consult an authorised service provider.
This unit must be installed by a professional according: RD 795/2010, RD 1027/2007 and RD 238/213.
TROUBLESHOOTING
Cause
45
What should be done?
Wait for power to be restored.
Check that plug is securely in wall
receptacle.
Replace the fuse.
Replace the battery.
Wait or cancel timer setting.
Set temperature correctly. For
method please refer to "Remote
controller instruction" section.
Clean the air filter.
Close the doors or windows.
Clear obstructions away first, then
restart the unit.
Wait.
detailed