Troubleshooting - Powerplus Mustang Bedienungsanleitung

B U I L D I N G A T R A C K
B U I L D D I F F E R E N T S H A P E S
H A N D G E N E R A T O R
Hold the generator on your hand an rotate the handle with your other hand to generate energy.
No batteries, no AC-power needed. Create your own energy.
Energy saving, educational and environmental friendly.
Install the plugs of the hand generator
into the connector.
Keep your track clean
Use a soft fabric to clean the track
Built your track
on a flat surface,
otherwise track
To connect the cars correctly
can be damaged
on the track, make sure the
metal brushes on both sides
are in good contact with the
metal surface of the track.
T R O U B L E S H O U T I N G
PROBLEM
Cars don't run
Cars runs slowly
Car jumps off the track
C O N N E C T I N G T H E C A R S
Metal brush
Test the car by holding it in
the above position. Ask
somebody else to rotate the
hand generator. If the wheels
do not spin, plug the generator
in the other connection input.
P A R T S R E P L A C E M E N T S
T R O U B L E S H O O T I N G
1. Check to see if the metal brushes have good contact with
the track.
2. Check to see if the connector has been plugged in correctly.
3. Check to see if the track sections are correctly fitted together.
1. Check to see if the track sections are correctly fitted together.
2. Check to see if the track and tyres are dirty.
3. Check to see if the car body and the wheel shaft are correctly
fitted together.
1. Check to see if the central pin is broken. Replace with spare
one if necessary (spare parts are not included).
2. Check to see if the rear wheels are worn. Replace with
spare ones when necessary.
After setting the car on the track,
you can use the hand generator
to control your car for an
exciting race.
Please note that the cars can only
move in forward direction.
In case the metal brushes and rear
wheels are damaged or worn after extensive
use, replace them with spare ones.
Replacing parts should always be done
by an adult.