EN
Battery Pack for Impacto
Charging
• Charge the battery pack before using it for the
first time.
• Charge the rechargeable battery with one of
the cables supplied with the Impacto at any
voltage-carrying USB port (e.g. USB power
supply).
• For charging you must remove the battery pack
from the Impacto.
• Connect one end of the charging cable to the
battery pack (refer to illustration 1-1) and the
other end of the charging cable to the USB
connection.
• The LED on the battery pack (refer to
illustration 1-2) displays the charging status:
LED red
Charging of the battery
pack
LED white
Battery pack is full
LED does not
Battery
illuminate
charged
Warning and notice
1. Do not dismantle, open or shred the battery pack.
2. Do not short-circuit a battery.
3. Do not expose the battery pack to heat or fire, Avoid storage in direct sunlight.
4. Do not expose the battery to mechanical shock.
5. In the event of a cell leaking, do not allow the liquid to come into contact with the skin or eyes.
If contact has been made, wash the affected area with copious amounts of water and seek medical
advice.
6. Keep the battery pack clean and dry.
7. Wipe the battery terminals with a clean dry cloth if they become dirty.
8. Batteries need to be charged before use. Always refer to user instructions and use the correct
charging procedure.
9. Batteries give their best performance when they are operated at normal room temperature.
10. At the end of its operating life this product may not be disposed of along with normal household
waste. Please take it to a designated recycling point for electric and electronic appliances. This is
indicated by the symbol on the product, the operating instructions or the packaging.
Technical specifications
Operating / charging temperature range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to 35 °C
Detailed technical specifications can be found on the internet at:
www.beyerdynamic.com/impacto
Non-contractual illustrations. Subject to change without notice.
EN-DE 1 / Battery pack Impacto (09.17)
pack
is
not
Illustration 1-1
Micro USB connection
to charge the battery pack
Illustration 1-2
LED to display
charging status