Replacing The Battery; Cleaning And Maintenance - Max 59515 Gebrauchsanweisung

If you want to � nd the warmest spot on a
surface, hold the on/off button pressed and
move the thermometer up and down across
the surface until you � nd the area with the
highest temperature.
If you want to measure a shiny surface, it may
be necessary to apply masking tape to it � rst,
or to paint it black to avoid a re� ection.
Other functions and settings
Press the MODE button (3) one or more times
to change between the diff erent displays:
MAX The MAX (H) symbol is shown on the
display. The display shows the highest
measurement recorded.
MIN The MIN (I) symbol is shown on
the display. The display shows the
minimum measurement recorded.
EMS The EMS (G) symbol is shown on
the display. The display shows the
emissive power value, which by
default is set to 0.95. This setting is
suitable for most painted surfaces and
organic materials. Press the laser and
background lighting button to change
the value to 0.8.
CAL The CAL (F) symbol is shown on
the display. The display shows the
calibration value, which by default is
set to 0. You can change this value by
+/- 5 °C using the buttons (2, 4).
Example: If the actual temperature is
25 °C, and the measurement shows
26.3 °C, you can set the calibration
value to -1.3 °C.
20

Replacing the battery

When the battery low symbol (E) appears on
the display, replace the batteries with 2 new
equivalent 1.5 V AAA batteries.
Remove the battery cover, take out the used
batteries and insert two new ones. Please
ensure that the poles are correctly aligned.
Replace the battery cover.

Cleaning and maintenance

Clean the lens with compressed air or an
aerosol containing clean air. If necessary,
wipe the lens with a swab dipped in distilled
water.
Wipe the thermometer with a well-wrung
cloth after use, and always keep all surfaces
clean.