Johnson Soap Betriebsanleitung Seite 6

A. Batteries compartment cover
C. Soap leakage lip
D. Container cover
E. Soap container
F. Infrared sensor
1. Never wash the appliance because the
water can damage the electrics parts. If it
is necessary to clean the appliance, turn it
off and clean the outside surface with a
soft damp cloth.
2. The soap dispenser is designed to sup-
ply fluid liquid soap. Foamy soaps or
soaps that contain granules or small
pieces of fruit, etc, should not be used be-
cause it may block the spout.
1. Installing or replacing batteries
Remove the battery compartment cover on
the bottom of the appliance.
1.1 Install 4 AAA batteries 1.5 V, observ-
ing the correct polarity +/- as indicated in
the compartment.
1.2 Replace the cover of the batteries
compartment.
: to avoid accidental dispensing of
soap, we recommend to install the batter-
ies before filling the SUPPLY reservoir.
1.3 Replace the old batteries with new
ones when the "automatic supply" become
weak.
1.4 Hold ever the soap reservoir cover
when it is necessary to turn upside down
the appliance to replace the old batteries.
1.6 Always remove the batteries of the ap-
pliance before a long period of inactivity.
1. Addition of soap and/or disinfectant
into the reservoir.
1.1 Reach the SUPPLY RESERVOIR by lifting
the cover.
1.2 fill the SUPPLY reservoir with disinfec-
tant liquid soap or lotion.
1.3 Replacing the cover.
: ensure that the quantity of liquid
added does not exceed the "Max" level
marked on the outside of the reservoir.
2. Enable automatic supply.
2.1 Put your hand under the spout, the in-
frared sensor detects it and then automat-
ically delivers the correct amount of liquid
from the nozzle. The automatic stopping
of the supply is indicated by the turning
off lighting.
On first use, turn on repeatedly the "au-
tomatic supply" until the supply becomes
normal.
● At any time, do not immerse the appli-
ance in water to prevent the malfunction
of the electrical parts inside.
● Always place the appliance with the ver-
tical reservoir on a stable surface.
● To have a normal "automatic supply",
not mix the water with liquid soap or dis-
infectant lotion.