Installation; Specifications - Smanos RD-20 Handbuch

EN

Installation

Place the reader outside the entry door of your home where it is
easy for you to access on your way out/in.
Rotate the reader and swipe your tag on the sensing area to arm
the system and check the connection with the Hub.
PFID Reader PFID Reader
Important: Make sure the UP mark on the Back Cover is pointing
up before mounting on a flat surface. Once level, you can install
the reader by using either the double-sided tape or the screws
with mollys included in the package.
Notice: Removing the Back Cover off of this reader will trigger the
alarm; you can disarm the alarm and continue the installation.
Removing RFID Reader from the K1/K2 Hub
In the smanos home app accessories page, slide the reader from
right to left. Then tap on the ashbin icon to remove reader from
hub.
Removing RFID Tag from the K1/K2 Hub
In the smanos home app RFID reader page, slide the tag from right
to left. Then tap on the ashbin icon to remove tag from hub.

Specifications

Model: RD-20
Power: 3V CR123A li-Mn battery X 2 pcs
RFID tags supported: 50 pcs
Radio Frequency: 868MHz(EAN 8718868403971) or 915MHz
*Only 868 MHz is available for Europe
Wireless range: ≤ 80 m (in open area)
ERP (dBm) Max.: -13.65
Operation condition:
0-50°C/32°- 122°F, humidity < 90% RH (non-condensing)
Dimensions (L x W x H): 80 X 80 X 35 mm/3.15" X 3.15" X 1.34"
EN