Kenwood PS-60 Bedienungsanleitung

DC POWER SUPPLY
PS-60
INSTRUCTION MANUAL
We are grateful you purchased this KENWOOD DC Power
Supply.
SUPPLIED ACCESSORIES
AC Power Cable (2 m/ 6.5 feet) .......................................................1
Instruction Manual ..........................................................................1
Warranty Card ................................................................................1
PRECAUTIONS
• Do not expose the unit to rain or moisture to avoid the risk of
fire or electric shock.
• Do not touch the power plug when your hands are wet to avoid
risk of electric shock.
• Do not remove the case. Accidentally touching an internal part
may result in serious electric shock.
• If a metal object such as a hair pin or a needle comes into
contact with the power socket on the rear panel, a dangerous
electric shock may occur.
• Keep children away from the unit, to avoid unnecessary risk of
harm to the child.
• Always remove the plug from an AC outlet by pulling on the
plug, not the cable.
• Position the AC cable so it will not be stepped on, tripped over,
nor subjected to damage.
• Plug the AC cable only into a grounded AC outlet.
• Unravel the AC power cord before use.
• In case of an abnormality in the equipment, ensure the
equipment is plugged into an outlet that can be easily accessed,
so that the plug may be disconnected from the outlet.
• To avoid equipment damage, do not connect to a transceiver
that operates on a voltage other than 13.8 V DC or exceeds
the current rating.
• Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid areas,
nor on unstable surfaces.
• Do not block the power supply air vent. Do not cover the unit.
To maintain good ventilation, place the unit at least 10 cm (4
inches) away from the wall.
• Do not use solvents such as benzene or paint thinner to clean
the unit. Use a silicone or a clean, dry cloth.
• Do not install this equipment in a constricted location, such as
a book case.
• If you detect an abnormal odor or smoke coming from the unit,
turn OFF the power immediately and disconnect the power
cord. Contact your KENWOOD service center or dealer.
Information on Disposal of Old Electrical and Electronic Equipment (applicable
for countries that have adopted separate waste collection systems)
Products with the symbol (crossed-out wheeled bin) cannot be disposed as
household waste.
Old electrical and electronic equipment should be recycled at a facility
capable of handling these items and their waste byproducts. Contact your
local authority for details in locating a recycle facility nearest to you. Proper
recycling and waste disposal will help conserve resources whilst preventing
detrimental effects on our health and the environment.
ORIENTATION
Front Panel
Indicator
DC POWER SUPPLY PS-60
(Red)
(Output
monitor)
Power switch
Power switch
Press this switch to turn the power ON and OFF.
Rear Panel
Cooling Fan
• This power supply is for use with a transceiver . Do not use
the power supply with other products.
• Before connecting the DC power cable to the transceiver
terminal, or removing it from the terminal, turn the power
supply power OFF.
• For connection instructions, refer to the transceiver instruction
manual.
• When placing the power supply beside the transceiver, adjust
the power supply bail to an appropriate angle. You can further
use commercially available rubber pads/ feet to adjust the
angle to match that of the transceiver.
SPECIFICATIONS
Power requirements .................. 100 V - 240 V AC ±10%, 50/60 Hz
Output voltage ......................................................... 13.8 V DC ±5%
Rated output current .............................................................. 22.5 A
Operating temperature range .... –10°C ~ + 50°C (–22°F ~ +130°F)
Dimensions (W x H x D) <without projections>
.................... 173.5 x 95.5 x 204.3 mm (6.83 x 3.76 x 8.04 in)
Dimensions (W x H x D) <with projections>
.................. 175.9 x 108.6 x 228.1 mm (6.93 x 4.28 x 8.98 in)
Weight ........................................................... approx. 2.5 kg (5.5 lb)
AC Plug ................................................................ 3 pin (Grounded)
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN
EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED"DANGEROUS VOLTAGE"WITHIN THE
PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE
TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
The equipment is designed for connection to an IT power distribution system.
B62-2297-50 (E) (1/7)
bail
AC Power
Cable
"+" Terminal
"−" Terminal
© 2019