Installation - Desoutter 6158122810 Bedienungsanleitung

6159921240_03
Original instructions.
© Copyright 2016, Ets Georges Renault 44818
St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
The barcode reader accessory is designed for
being installed on Desoutter EPBC nutrunners.
No other use is permitted.
For professional use only.
OVERVIEW
● See page 3.
1 Barcode reader
2 Protection cover
3 Fixing kit
4 Connection board
TECHNICAL DATA
● See page 3.
● Contact your local Desoutter
representative for more information.

INSTALLATION

Caution!
● Before mounting the accessory,
check that the tool, the controller
and the sofware releases are
compatible.
Tool software version
CVI3 controller
CVI3 Suite
● Mount the accessory as described from
page 5.
● Connect the tool to the controller, the green
LED "Power on" is blinking (see page 9).
● Launch "CVI MONITOR".
≥ 4.7.X
≥ 1.6.9.X
≥ 2.1.8.X
10 / 56
● In the tab "Tool identification", click "Barcode
reader" to declare the accessory. Click "Write
to tool" to update the tool memory.
From that moment, the LED "Power on" turns
steady. If not, check the mounting of the
accessory.
The tool is ready to run.
Other settings possible with CVI CONFIG
● Launch "CVI CONFIG" and go to the "Tool"
tab.
● Extend or shorten the scan time from 1 to 9
seconds.
● Use the trigger to scan the barcode. In that
case, the tool must be locked before pressing
the trigger and the "Stop" icon displayed on
the controller display.
● To prevent the operator from using the "Scan
button", untick the box "Scan button".
● Refer to the CVI CONFIG user
manual at http://resource-center.
desouttertools.com
OPERATING MODE
● See page 9.
LEDS COLOR CODE
A
1 Power ON
2 Scan
3 Scan OK
4 Scan button
5 Laser beam
Warning!
Laser radiation
● Do not stare into beam.
● Press briefly the "Scan button"
The orange LED "Scan" is activated during 3
seconds by default.
As soon as the barcode is read, the beam comes
off, the green LED "Scan ok" is on.
English
06/2016