Regin E-BACNET2-V Anleitung

INSTRUCTION
EN
E-BACNET2-V
i
Read this instruction before installation
and wiring of the product
EXOline to BACnet converter
E-BACNET2-V is a pre-configured converter for connecting a Corri-
go E running a ventilation application version 3.0 or later to a SCADA
system. Communication with the Corrigo takes place via EXOline
RS485 and is pre-set to PLA:ELA address 254:254. Communica-
tion betweeen the converter and the SCADA system takes place via
BACnet/IP.
Technical data
Supply voltage 12...48 V DC
Power consumption 4.5 W
Dimensions (WxHxD) 77 x 111 x 26 mm
Weight 190 g
Mounting Wall*
Ambient temperature -10...+60°C
Ambient humidity 5...95 % RH
Storage temperature -20...+80°C
Ethernet connections Two, automatic change-over
10/100 Mbps
Inputs Two RS232/422/485 (9-pole D-sub)
* DIN-mounting kit available as an accessory
Mounting
Mount the converter directly on a flat surface, e.g. using a mounting screw
(not included). A kit for DIN-mounting is also available as an option. The
transformer should preferably be mounted using a cable tie.
Black model
Wiring
Connect the RS485 cable to the S0/P1 port on the converter and to the B,
A and N terminals (50, 51 and 52) on the Corrigo. Connect E-BACNET2-
V to the local network by connecting the RJ45 cable between the ETH0/
LAN1 port of the converter and a network port. The converter may also be
connected directly to a computer, but this requires a crossover RJ45 cable
(not included).
Connect the power supply to the converter and to the Corrigo E. Please
note when wiring the supply voltage into the converter: V + is marked
while V - is entirely black.
It will take approx. one minute for the converter to start up. When the
unit is ready, the Ready light will be lit. If the Corrigo connected has the
PLA:ELA address 254:254, the converter will begin communicating. This
is indicated by the S0/P1 TX and RX lights blinking. The unit is now also
available in the BACnet network.
E-BACNET2-V
Power plug
Adapter
Ready
TX
RX
TX
RX
Blue model
S0
Corrigo E
Default parameters
BACnet Device Object Name
BACnet Device ID
Network card
Corrigo E address
Trafo
Network
(Computer)
RJ45
-
+
V- V+ ETH0 ETH1
(WAN) (LAN)
S0
S1
RS-232/422/485
S1
E-BACNET2-V$
(where $ is replaced with the
BACnet Device ID)
The factory setting Device ID
constitutes a randomly generated
value that should be changed
during initial start-up. This
change is performed using the
configuration tool.
192.168.92.92/24
PLA = 254
ELA = 254
1