Werbung
As to general safety operation
and power head operation such
as engine starting/shut off,
etc. please refer to the owner'
s manual provided with your
HITACHI brush cutter.
1. Remove attachment from
your brush cutter.
2. Join the attachment in place
of it.
3. Make sure the locking bolt
(1) fits in the location hole (2)
of tube and that the tube will
not come off.
4. Tighten the clamp bolt (3)
securely.
1) Install safety cover (3) and
the collar (4) of Mini-culti by
inserting onto shaft pipe (5)
and fix it temporarily keeping
the model name on the cover
upright. (Fig. 2)
After installation, you cannot
turn tines by hand due to its
worm gear mechanism.
2)Finally secure the safety
cover more than 40mm from
gear case.
1) How to till:
a. For standard tilling. Walk
forward as pulling and
pushing the unit little by little
like using a vacuum cleaner.
(Fig. 3-1)
When you want to erase
your foot-prints, pull the unit
backwards. (Fig. 3-2)
b.For shallow tilling, move the
unit quickly over soil surface.
(Fig.3-3) For deeper tilling,
hold the unit over the same
area with the gentle back and
forth motion. (Fig. 3-4)
a. Working throttle position
depends on your size of
engine and tilling depth but
half way open is standard. If
tines rotate too fast, the unit
is likely to hop.
b. Do not work in rocky area. If
the tines jammed with rock or
hard soil, or tangled around
with long grasses, shut off
engine first, then remove the
obstruct. (Fig. 3-5)
c. Do not use the unit in water
or rooted, vine area.
(Fig. 3-6, 7)
d. The tines are preassembled
at factory, when reassembling
them, be aware of their
direction.
e. Do not touch gear case
with bare hand right after
operation. It gets hot.
f. Supply proper amount of
lithium-based grease, such
as Shell Aluvania grease R2,
Shell Aluvania EP grease
2, Mobile-Mobilux EP2 or
equivalent after every 25
hours of use. (Fig. 3-8)
g. When reassembling, be
sure to use 40 grams of
molybdenum added lithium-
based grease or Sell retinax
AM or equivalent.
G
B
Werbung
