Performance Test; Safety In Use - Ropox Vision Benutzerhandbuch Und Montageanleitung

9. Performance test

After completed installation and before use, all functions of the table must be tested. After that, a
performance test must be carried out at least once a year by competent personnel.
7. Check that the mounting instructions have been observed.
8. Check that all bolts have been tightened.
9. Make sure that there is no load on the table.
10. Make sure that there are no objects or the like preventing the table from moving unhindered
within the range of height adjustment.
11. Place the handle as illustrated in the manual and adjust the table to bottom position. Check that
the movement is even and smooth.
12. Now adjust the table to top position and check that the movement is even and smooth.
When these tests have been carried out successfully, the table is ready for use. See "Safety in use", Section
10.

10. Safety in use

➢
Vision must only be used by persons, who have read and understood these instructions.
➢
Vision is an activity table and must not be used as a lifting table or person lifter.
➢
Always use the table in a manner excluding the risk of damage to persons or property. The person
operating the table is responsible for avoiding damage or injury.
➢
Make sure that there is free space above and below the table to allow height adjustment.
➢
Do not operate the table in case of defects or damage.
➢
Do not overload the table and ensure that the load distribution is correct.
➢
During inspections, service or repairs any load must be removed from the table.
➢
Modifications, which may influence the performance or design of the table, are not allowed.
➢
Assembly, service and repairs must be carried out by competent personnel.
➢
If the table has not been assembled according to these mounting instructions, the guarantee may
become void.
➢
Only use Ropox original spare parts for replacement. If other spare parts are used, the guarantee
may become void.
25
© ROPOX 2015