Monarch 9465 Betriebsanleitung

O P E R A T I N G I N S T R U C T I O N S
The Monarch® 9465™ Four-Station Battery Charger
charges from one to four 7.4V lithium-ion batteries (p/n
12009502) at a time.
Note: You must charge a battery before using it.
Information in this document supercedes information in
previous versions. Check our Web site
(www.printers.averydennison.com/en/home.html) for the
latest documentation and release information.
♦ Use only a Monarch-qualified battery. The battery could be damaged or explode if
placed on a different charger.
♦ Do not charge non-rechargeable batteries in this charger.
♦ Do not throw the battery in the trash. Dispose according to your local regulations.
♦ Do not disassemble, short-circuit, heat above 80°C, or incinerate the battery. It may
explode.
♦ Follow the operating and storage limit specifications listed at the end of these
instructions. Otherwise, the battery may permanently lose its charge capacity.
♦ The unit is for use only with Listed ITE.
S e t t i n g U p t h e E q u i p m e n t
To set up the equipment:
1. Plug one end of the power supply into a wall
electrical outlet.
2. Plug the other end of the power supply into the back
of the charger. The Power LED is on when the
charger is set up and plugged in.
C h a r g i n g a B a t t e r y
To charge a battery, insert the battery into the charger
as shown. Charging time can take up to three hours. It
takes approximately two hours to reach the 80% level
(where it is now usable). To reach 100%, it takes
approximately one hour more.
TC9465OI Rev. AL 11/17
WARNINGS
©2009 Avery Dennison Corp. All rights reserved.
E N