Looox LED RGBW REMOTE CONTROL Gebrauchsanleitung Seite 3

Instructions
EN
Dynamic mode:
Static colours:
Brightness:
Speed:
Demo mode:
Removal:
Memory:
Remote control
Remove the protective foil from the remote control before initial operation. Also, disconnect the protective
insulation of the battery. The battery is 3V CR2025, please use this battery only in the remote control.
Features
1. Power on / Standby:
Press this button to turn on the device or
switch to standby mode. The unit is turned on
and restores the previous status.
2/9. Setting dynamic modes:
Switch from static colour mode to dynamic
mode or switch between dynamic modes.
3/8. Dynamic speed adjustment:
Adjust dynamic speed. Press the + button to
increase the speed and press the Speed button
to decrease the speed to enter the dynamic
mode when you press this button in static
colour mode.
LED RGBW REMOTE CONTROL
19 modes
20 colours
5 levels
10 levels
Yes
> 30m in an open area
Automatic memory function
1
2
3
SPEED
4
COLOR
5
COLOR
4/5. Static colour adjustment:
Switch from dynamic mode to static colour
mode or switch between different static
colours.
6/7. Brightness adjustment:
Adjust the static colour brightness. Press Bright
+ to increase the brightness and press Bright -
to decrease. The unit enters static colour mode
when this button is pressed in dynamic mode.
10. Demo mode:
Press this button to enter demo mode. Demo
mode repeats 9 dynamic modes, repeating
each mode 3 times.
10
MODE
8
SPEED
DEMO
9
7
BRIGHT
MODE
6
BRIGHT
RF Wireless
3