Getting Started; Pairing Mode - AMP SP1 Plus Bedienungsanleitung

Getting Started

Pairing Mode

NFC
EN
Please fully charge your SP1
Plus before initial use. Connect
the included Micro-USB cable
to your SP1 Plus and a USB
slot of any PC/Mac or USB wall
charger to charge. The RED
LED will turn on while charging
and will turn off when finished.
Push and hold the FUNCTION
button for 6-8 seconds until the
WHITE LED flashes.
If your device supports
tap-to-pair NFC (Near Field
Communication) please enable
Bluetooth and NFC on your
phone and tap the NFC pairing
logo.
Connections
Dual Pairing
If you own two SP1 Plus you may use the Dual Pairing functionality to
play music from two units simultaneously.
Connect your primary SP1 Plus to your music device via Bluetooth as
instructed in the Paring Mode section.
Primary - Left Channel
Enter Dual Paring mode by holding down the FUNCTION and volume
up "+" button for three seconds until the indicator switch flashes RED
and WHITE.
Secondary - Right Channel
On your second SP1 Plus hold down the FUNCTION button and the
volume down "-" button for three seconds. The indicator switch flashes
RED and WHITE as it is pairing and becomes a solid WHITE when
successfully paired.
Note: Volume can be adjusted from either SP1 Plus
AUX mode does not support dual paring
You may connect to your
device via Bluetooth or 3.5 mm
stereo input cable.
EN