Active Era PREMIUM AIR BED Single Bedienungsanleitung Seite 3

Inflation
1. Choose a flat, indoor surface large enough to
accommodate the inflated airbed
Remove any sharp or pointy objects on or
2.
near the surface
3. Lay the airbed out with the bottom surface
touching the floor
4. Open the cover at the top of the bed where
the power cord is stored
Make sure the manual inflation valve is
5.
closed
6. Plug the power cord into an electrical outlet
7. Turn the control dial clockwise until the arrow
points to INFLATE (image 1)
The single airbed will take up to 1.5 minutes
8.
to inflate. The queen size airbed will take up
to 3 minutes to inflate
9. When the airbed is fully inflated, turn the
control dial one click anti-clockwise until the
arrow points to OFF (image 2)
Lie down on the airbed to test the firmness.
10.
If too soft, repeat steps 7 – 9 as necessary
11. Unplug the cord and store in the power cord
compartment
Inflation Option
If electrical power is not available, then a conventional foot or manual
operated air pump can be connected to the airbed
Image 1
Image 2
English | 2