Lamp Replacement; Dmx Linking - Chauvet Professional Rogue R2X Beam Schnellanleitung

Replacing The Fuse
1. Disconnect this product from power
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

Lamp Replacement

1. Turn the fixture off and disconnect it from power.
2. Wait at least 15 minutes for the lamp to cool down.
3. Remove both head covers by removing 8 Phillips-head ¼-turn screws.
4. Orient the rear of the product so that the fan is facing downward.
5. Remove the 2 wires connected to the lamp by the spade terminals.
6. Using the lamp base, push the lamp left against the spring clips located on the left, then roll the lamp out the top.
7. Reverse the steps above to install the new lamp.
Please refer to the User Manual for more detailed instructions.

DMX Linking

The Rogue R2X Beam will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Rogue R2X Beam uses a 3- or 5-pin DMX data connection for its 2 DMX personalities. See the User Manual for
information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Rogue R2X Beam supports RDM protocol that allows feedback to make changes to menu map
options. Download the User Manual from
Rogue R2X Beam QRG Rev. 3
QUICK REFERENCE GUIDE
www.chauvetprofessional.com
1/4-turn Phillips-head screws
for more details.
EN
2