Konig Electronic SEC-UNIT40 Anleitung Seite 4

ON/OFF
Button to switch the monitor ON or OFF.
CH (Channel select / Auto switch)
Select the channel you wish to watch; simply by pressing the channel selection button on
the monitor for desired channel (press once for CH 1, press again for CH2).
Keep on pressing the CH button (± 5 seconds) until the monitor switches to auto-scan
channel selection with 5 seconds interval. Press again the CH button to switch to manual
CH selection.
Remote control:
Push CH1 to select channel 1
Push CH2 to select channel 2
Push SCAN to start auto-scan channel selection
Connecting the cameras to the monitor:
1. Connect the DIN connector from the DIN cable (1) with the DIN connector from camera 1.
2. Connect the RCA connector from the DIN cable with the input connector on the monitor
for camera 1.
3. Repeat above steps for camera 2.
4. Connect the AC/DC adapter with the monitor and an outlet.
5. Switch on the power and check if system works.
Camera 1 Camera 2
(2) Din assignment (2) Din assignment
(1) 60ft Din
(1) 60ft Din
to Phonejack
to Phonejack
Cable
Cable
Audio RCA
Video RCA
AC Adapter
4