Assembling The Appliance; Switching On The Appliance; Operation - ARTEM HEATMASTER 02011 Betriebsanleitung

Assembling the appliance

Insert the support tube in the lower part of the appliance
Connect the plug in the socket, avoiding the use of reducers.

Switching on the appliance

Plug the electrical supply cable into the electric socket, ( placed under control panel).
Switch the device on using the switch (A).
Turn the timer (B) to the working time required.Press the switch (C) to obtain the ventilation required.
Place the dishes approximately 200-250 mm from the client's head (standard advised distance).
Switch the lamps on singly according to the number of lamps required using the switches (D) placed on the
control panel, When the led is switched on the infrared lamp is working.

Operation

Pressing the switch
Position 1° => released switch => Lamp on at half power
Position 2 ° => pressed switch => Lamp on at full power
Pressing the switch
Position 1° =>(released switch => Half speed of ventilation
Position 2 => pressed switch => Maximum speed of ventilation
Safety regulations - warnings
Do not use this appliance near bath-tubs, wash-basins or other recipients containing water.
As there is danger even with the appliance disconnected, remove the plug from the socket when the
appliance is not being used. Further protection can be provided by installing a 30mA differential switch.
The appliance generated heat, handle with care, DANGER.
Do not place tissues on top of the appliance, DANGER.
The device is not meant to be used by persons (including children) whose physical, psychological or
sensorial abilities might be reduced, or by persons with no experience or knowledge of the use unless
supervised by a person responsible of their safety or duly instructed by such a person on the uses and
precautions needed to handle the machine.
Children must be supervised in order to keep them away from the device and in order to prevent them from
playing with it.
If the power cable is damaged, it must be replaced by the constructor or by their technical service, or, in any
case, by an equally qualified person, to prevent all risk.
Pag.8
the infrared lamp get to the maximum power or medium power,
the speed of the fan will be regulated.