Care & Maintenance - aidapt VM844 Aufbau- Und Wartungsanleitung

BEFORE USE
Carefully remove all packaging. Avoid using any knives or other sharp instruments
•
as this may damage the product.
Check the product for any visible damage. If you see any damage or suspect a fault,
•
do not use your product, but contact your supplier for support.
Please read these operating instructions carefully before you operate the lock or try
•
to change the combination of numbers.
NB. The Key Safe is delivered without a code – you need to save your chosen code the
first time you use it.
HOW TO OPEN THE KEY SAFE FOR THE FIRST TIME
Push the CLEAR button down
•
Push the OPEN button down
•
You can now open the cover
•
HOW TO SAVE A NEW CODE
Choose your code (minimum 3 digits). We recommend using a 4 digit, non-
•
concurrent code with no repeated numbers, e.g. 4827 rather than 4485 or 8787.
Remove the back panel (#14) of the cover by removing the screw (#15) with a
•
screwdriver.
Set your chosen code by turning the corresponding plastic screw (#7) behind the
•
number by 180o so that the arrow on the screw (#7) points down. Repeat for each
digit in your chosen code.
You have now saved the code and the back panel can be replaced onto the cover.
•
HOW TO OPEN OR CLOSE THE SAFE
Push the CLEAR button down
•
Type the code in
•
Push the OPEN button down
•
You can now open/remove the cover or replace it to close the Safe
•
CARE & MAINTENANCE
Please make a check of the product at regular intervals or if you have any concerns.
Fitting and Maintenance Instructions
3
Ver. 2 08/2012 (2270)