Werbung
Verfügbare Sprachen
Verfügbare Sprachen
433 MHz (Rolling-Code)
≦ 8 dBm
2-Channel
suitable for outside use
Factory settings code for Channel 1 = 11 Factory
settings code for Channel 2 = 22
Programming instructions
1. Press the programming button on the opener/operator
2. On the code keypad, press "11" then the " < " button
3. The keypad is now programmed to the opener/operator
4. To open and close your gate/garage door opener, simply enter in the code "11" and press the " < "
button.
Changing the PIN code
1. Press and hold the "0" button followed bythe"<"button.
2. Release first the "<" button, then the "0".
3. Enter in the factory setting code "11" and press the "<" button.
4. Enter in your new desired code (up to 8 numbers) and press the "<" button when finished.
5. Enter your new code in again and press the "<" button again.
6. Your new code is now entered into the code keypad
7. Make sure to make note of your PIN code
Programming Channel 2 is the same as above, rather, change "11" to "22" and "<" to ">".
Schartec hereby declares that the radio installation type SKP complies with Directive 2014/53 / EU. The full text of the EU-Declaration of conformity is available at the
As a dealer for the distribution of electronic, battery-operated devices, we are obliged by law to inform our customers about the following:
Electrical and electronic devices, as well as batteries, must not be disposed of as household or residual waste, but must be delivered in the appropriate acceptance and
collection points will.
The complete version of the battery law can be found here:
Wireless Code Keypad SKP
Simplified Declaration of Conformity (CE)
following Internet address: www.schartec.de
Information about battery regulation
http://www.gesetze-im-internet.de/bundesrecht/battg/gesamt.pdf
Werbung
