Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
30 001 370-1
level meter
EPM300
EPM300 is a mobile device for radio link range testing. It helps electrical installers to find the right
position to mount products supporting EnOcean protocol.
Before getting started:
1. Open battery cover on the back and insert a lithium or Alkaline battery type AA/LR06.
2. Activate the EPM300 by pressing the sensor pushbutton
Battery low will be indicated by flashing MODE LED.
3. Send an EnOcean telegram via wireless pushbutton or according to the operating manual of
another sensor.
4. Signal strength (RSSI value) will be shown by a reverse traffic light (colours green, yellow and red).
Interpretation of signal strength value:
The Valid-LED shows the reception of a valid EnOcean telegram. This can be a telegram of a
pushbutton or a teach-in telegram of another sensor. An indication of received signal strength
without Valid-LED indicates to a cable allocation by another transmitter.
Additional features for repeater mode and radio link test:
more information about range planning can be fount at:
http://http://www.enocean.com/en/application-notes/
AN001: installation notes for EnOcean wireless systems
WEEE registration number DE 30298319
11/2011 Subject to change without notice.
Indication of received signal strength
EnOcean telegram
Selection of
operating mode
ON/OFF button
MODE button
red
Range test with peak hold short time (1 second)
Range test with peak hold short time (60 seconds)
Repeater on (1-level)
Radio link test on, send test telegram every 2 seconds
for 2 seconds.
use a repeater
good reception, internal
antenna is sufficient
yellow
green
Werbung
