Assistance - After Sales Service - Warranty - PEUGEOT Energyscroll 400 Bedienungsanleitung

Trooble shooting
PROBLEM PROBLEM CAUSE
Breaking blades 1. Wrong tension
2. Over working
3. Wrong blade application
4. Twisting blade in wood
Motor is not run 1. Defective lead or plug
2. Defective motor
Excess vibration 1. Improper mounting of the hole
2. Unsuitable mounting surface
3. Loose table or table resting against motor
4. Loose motor mounting
Blade runout Blade holders not aligned
Blade not in line with arm
motion
All Peugeot machines and accessories are manufactured in accordance with high quality standards and come with after-
sales service provided by a network of approved after-sales service centres. Please contact a PSP Tooling retailer for more
information about our products or for spare parts, after-sales service or details about the guarantee.
PSP Tooling is proud of the quality power tools it sells. The components of our tools are inspected at various stages of pro-
duction and each finished tool is subjected to a final check before being packaged for shipment. Because of our confidence
in our engineering quality, PSP Tooling agrees to repair or replace any part or parts of Peugeot power tools and accessories
which examination proves to be defective in workmanship or material. The warranty period for Peugeot brand is two years.
Any alleged defective part or parts must be returned prepaid to PSP Tooling or one of the service centres. The guarantee does
not include repair labour or parts replacement required because of misuse, abuse, or normal wear and tear. Repairs made by
other than our factory, service centre or authorized service station relieve PSP Tooling of further liability under this guaran-
tee. THIS GUARANTEE IS MADE EXPRESSLY IN PLACE OF ALL OTHER GUARANTEES OR WARRANTIES, EXPRESSED OR IMPLIED,
WITH RESPECT TO QUALITY, MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE.

ASSISTANCE - AFTER SALES SERVICE - WARRANTY

PSP Tooling GUARANTEE
REMEDY SUGGESTED
1. Adjust blade tension
2. Reduce feed rate
3. Use narrow blades
4. Avoid side pressure on blade
1. Replace defective parts
2. Consult service center
1. See "Mounting the tool to a bench"
2. The heavier your workbench is the less vibration will
occur. Use common sense in choosing a mounting surface.
3. Tighten table lock handle
4. Loose motor mounting
Loosen cap screws holding blade holders to arms. Adjust
position of balde holders. Retighten holders.
5