aerosoft Raildriver's CabController Handbuch Seite 13

Wait until the HUD is shown completely and the position of all controls have
been synchronized. This may take a few seconds. Please note that the HUD is not
hidden by any other windows (Track Monitor F4 or Time Table F10).
7.You are now able to control your train with the CabController.
You can use your keyboard and the CabController at the same time. By using the
button „Start/Stop RailDriver" you can activate or deactivate the RailDriver dur-
ing a train Simulator session.
If you should still notice problems while using the
RailDriver CabController you should consider the fol-
lowing:
In order to run the CabController without problems
please make sure that the HUD is displayed correctly
as the CabController receives all needed information
from this HUD. A malfunctioning of the HUD can be
recognised when all buttons are still functional but
the operating of the controls shows no reaction and
no speed is shown in the LED-display (only three hori-
zontal lines are shown).
Make sure that no other windows cover the HUD.
If the CabController still does not work properly,
please check the settings of your graphics card
which also has some influence on the Heads Up Dis-
play. Close your Train Simulator first and then open
the settings of your graphics card. Check the power
and quality settings as well as the 3-D settings. An-
tialiasing and Anisotropic filtering should not be
activated. Switch off these settings. Also make sure
to set the texture quality to maximum.
Where the sliders for these settings are to be found
is dependant on your graphics card and its installed
driver.
See below the settings for the most common graphics cards for ATI and NVidia.
13