Inhaltsverzeichnis
Werbung
Operation
1. Insert the USB cable into the 5V power
2. Plug the power supply into an AC power
3. Open the lid of your Widex DRY-GO UV.
4. Remove the batteries from the hearing
5. Briefly touch the sensor button and then
14 0251 001 #05.indd 4
supply and the Micro-USB connector
into the socket on the rear side of your
drying station. Illustration 1.
socket. Illustration 1.
aids. Place the pre-cleaned earmoulds
and hearing aids in the drying station
with the battery drawer open.
Illustration 2.
close the lid. Illustration 2.
•
The drying programme starts, and
will stop automatically after three
hours.
•
An LED light indicates that the unit is
on.
•
A blinking LED light indicates that
the UV-C light is on for the first
eight minutes of the drying period.
GB
4
27-11-2014 08:42:33
Werbung
Inhaltsverzeichnis
